NEXT
-18-
-19-
Reading Data stored In memory Ramdomly:
On read Status ,Press the "SAMPLE" Key and enter the
number of the record in questions and press "ENTER"
Key then the desired data will be displayed Press "
RESET" Key to exit As shown in following figure:
.In instantaneous data storage mode, you should
first press "SAMPLE" Key and input "0" second ,
then press "ENTER" to finish the rate set up.
b.Press the "REC" Key to finish the recording,
otherwise the recording will be invalid.
c.The maximum number of readings can be stored 500.
d.If your reading number is bigger than the total
quantity of data stored in memory ,the LCD will
shows the last stored.
Note :
a
Clearing the Stored data:
Press down the "CLEAR" Key for 5 seconds then
CRL appears on the LCDindicating , all the stored
data being Cleared. As shown in following figure:
Connection With Pc
1). Requirement of computer configuration:
CPU : Pentium 600MHZ Or above ;
One free available USB Connecting Interface;
The lowest screen resolution of monitor is 800*600 (
or much higher ),color mode;
At least 8MB available memory;
At least 50MB available disk memory;
Operation system : MICROSOFT WINDOWS 98/ME/
2000/XP HOME/XP PROFESSIONAL 32BIT
2). Install the software from the disc:
Place the attached Disc in your disc driver open the
disc driver plate symbol , double click the "
Anemometer setup .exe " .To enter into Program
installation window, click "NEXT" , as show in
following figure:
