MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 9. 2014
8
•
check the blind in the window wing so that the dimension corresponds to the width of the window; check that the control
mechanism is on the right side. If it is necessary to be changed, it is not possible to change it for any System 25 blind.
In this case, we recommend contacting the producer.
•
place the blind to the window wing and screw each holder, using the two screws, into the glazing bar to prevent
damage to the frame. For wooden windows the holes are pre-drilled to prevent cutting the glazing bar. Screw the solid
transparent consoles into the lower part of the glazing bar. Draw the nylon or wire through the clamping screw and
insert it into the solid console. Then, using your hand or pliers, tighten the nylon or the wire and tighten the worm in the
clamping screw. Cut the excessive nylon or wire.
If the shape or the size of the glazing bar does not allow drilling holes to secure the tightening pins into the glazing bar
from upwards, choose the option of drilling the holes for pins into the face of the glazing bar. In this case, take care not to
damage the glass with the drill. It is important to state the correct depth of the drilling! The client must be informed in
advance of this form of assembly and consent in writing in the handing over protocol. Finally, ensure the full functionality of
the blind and the window.
•
secure the chain limiter, for plastic windows and wooden Euro windows secure it only into the glazing bar or mount the
holder for fixation of the lever for the version with the lever.
•
check the function of the blind
ATTENTION!
During assembly it is necessary to place the blind in the window which is not unpacked; mark the position of the screws on
the window wing, fit the blind and then lower it. Each manipulation of the blind before assembly (if necessary) is only to be
performed in the horizontal position Any other manipulation is forbidden and claims for such damaged blinds will not be
accepted!
