MEASUREMENT AND ASSEMBLY MANUAL
Instruction validity: as of 1 August 2013
11
RTS MOTOR:
The motor cable has 3 conductors:
blue = phase/neutral conductor,
brown = phase/neutral conductor,
yellow-green = ground.
Motor switching can be installed in two different ways: either using a switch, or using a programming set (on request).
The
instructions for programming and adjustment of end switches are shown in a separate manual.
To set up the end switch, first turn on the motor to roll the roller blind down and set the required maximum down position,
then run the motor in opposite direction to draw the roller blind up.
Prior to final connection and operation, check if the system works properly. Operate the roller blind for at least two
consecutive cycles and check the function of thermal disconnection after 4 minutes of continuous operation. In case of any
problems, study Chapter 8.
NOTE: There is a risk of compression in case a hand is trapped between the fabric and the upper box during the
roller blind updrawing. Before operating the roller blind, move your hands outside of the movement range to
prevent compression. Vibrations or excessive noise indicate damage or faulty installation of the roller blind.
8.2 TESTING
To provide for proper function of the roller blind, check if the winding drum is perfectly level after installation.
Following the roller blind installation, check if the end user understands the method of operation of the roller blind, and give
this manual to the user for future reference.
8.3 REMOVAL OF WINDING DRUM FOR MAINTENANCE
Removal of the winding drum and motor from the upper box is necessary only if the upper box
is installed at the front. Suspended roller blinds are supplied disassembled.
NOTE: Prior to commencing the steps described below, disconnect the motor cables from the
main switch to prevent inadvertent motor actuating. On both sides, the box consists of side
board (1), fixed part (2) and removable cover (3). If it is necessary to remove the drum, first
remove two screws (4)
– one on each side – and remove the removable part of the box (3).
The roller blind components may vary in accordance with the roller blind dimensions and the motor type. The winding drum
is attached to the side boards as follows:
