March 2012
D. Troubleshooting
The front LED display does not illuminate.
Check that the 32Amp RCBO on the left hand side of the back
panel is turned on. Check that the power cable is correctly
connected to the power input socket.
Check that the mains cable is securely plugged into the wall
socket.
On rare occasions the fuse in the main distribution fuse box may
also need to be checked.
Check that the central front power on button is also turned on by
pushing full in.
The front LED display is on but I have no power to the outlets.
Check that each of the two power cells is on. These are turned on
by the two control buttons under the LED display screen. To turn
on outputs ‘1&2’ hold down the left control button for 3 seconds,
the screen will update and display this. To turn on outputs ‘3&4’
hold down the right control button for 3 seconds, the screen will
update to display this.
We would strongly recommend a simple check of mains polarity. Your
local IsoTek authorised dealer will be able to supply a product through
us to help you establish this. Mains polarity is of particular importance
in markets where European Shuko plugs are used.
Always replace fuses with the same fuse type and rating
.
Please contact us by email; [email protected] if you are in
any doubt about the correct fusing or need further help with fault
finding.
Fault finding
Fuse location & Power switch
Fuse in UK three pin plug
EVO3-Genesis-Instructions_OLD-MiniSub-GII-Instruc.qxd 08/03/2012 11:01 Page 8