Isoplam L030002, User Manual

Page: 11 / 28

11
10. Starting
·
Warning! To read with attention the instructions before starting.
·
Warning!
IT RECOMMEND ITSELF THE MAXIMUM ATTENTION.
To remove the
keys and the possible adjustment tools. To put always the guards. To jam the
advancing wheel with the proper hook.
·
To read and to follow the instructions on the user manual for the diesel and
gasoline motors starting. Therefore to continue as follows:
1. – To turn on the fuel faucet;
2. – To adjust the STARTER in the ignition position;
3. – To keep the pulled lever that is at left side of the rudder (stop device for the motor
when it leaves itself the handle that will never permit the motor starting in lowered
position (this system is usually called “
dead man
”);
4. – To slowly pull the rope starting until to find the compression resistance, to continue
to slowly pull until to just pass it (see the picture 06);
5.
–
To release the rope wrapping it up again (see the picture 06);
6. – Therefore to pull with force (see the picture 07);
IF THE MOTOR FAILS TO START, TO REPEAT ALL OPERATIONS FROM 4 POINT
·
The Starter with the electric motor happens pressing the handle lever. To stop the
machine is sufficient to leave the lever. All machines equipped with electric motor
have the low voltage system.
·
To use the maximum warning on the blades and plate rotation during the motor
starting or pauses and during the job of floor smoothing.
Picture 06 Picture 07