iSocket
®
GSM 706/707
www.isocket.eu
© Copyright Intellectronics 2012
All rights reserved. Version 1.1.2-EN
- 10 -
English
The list of simple commands for management and configuration is shown in the following
table. The real response may differ from those indicated in the table, depending on the
command.
Command
Description
Response
Type
ON
Turn on main power socket
Power socket ON
Ctrl
OFF
Turn off main power socket
Power socket OFF
Ctrl
ON123
Turn on main power socket for 123 minutes.
Maximum value is 720 minutes.
Power ON for 123 min
Ctrl
OFF123
Turn off main power socket for 123 minutes.
Maximum value is 720 minutes.
Power OFF for 123 min
Ctrl
ONM
Turn on microrelay
Microrelay ON
Ctrl
OFFM
Turn off microrelay
Microrelay OFF
Ctrl
ONALL
Turn on main socket and microrelay
All ON
Ctrl
OFFALL
Turn off main socket and microrelay
All OFF
Ctrl
RESTART
Restart (return to the same status after a certain
period of time) main socket. Time for restart set
by RESTARTTIME.
Power socket restarted
Ctrl
RESTARTM
Restart microrelay. Time for restart set by
RESTARTTIME.
Microrelay restarted
Ctrl
RESTARTTIME=5
Configures time (in seconds) for RESTART
command. Maximum value is 600 seconds.
RESTARTTIME=5 – OK
30min
RESTARTTIME?
Informs about RESTARTTIME value
RESTARTTIME=5 seconds Inf
STATUS
Request for main power socket and microrelay
status, temperature, GSM signal, date, sensor's
status, etc.
Power socket ON
Microrelay OFF
Signal: Good (-67dBm)
TEMP: 25C
ALARMF: Disabled
ALARM status: No activity
Time: y/m/d,h:m:s
Ctrl
TEMPERATURE
Informs about temperature in the room. See
details in Chapter 7.
TEMPERATURE: 25C
Ctrl
RUNTIME
Informs how long main relay has been turned on
(since last restart or power on)
If you turn on the main socket manually before
the correct date was installed on the device, the
start-up time of the device will not be
recorded correctly.
Power socket is ON from:
y/m/d,h:m:s
Ctrl
4.2 Managing by Phone Call
The main socket for external electrical equipment can also be managed by mobile or
landline phone. For example, you can call to the phone number of the SIM-card in the
device and the equipment connected to the device (e.g. computer) will be restarted.
After a call to iSocket the action occurs immediately. The action must be pre-configured.
There is no action configured by default. Keep in mind that you are not able to configure
the active actions if the security number list (Chapter 5.1) is not configured. This is
because the password protection is not available for calls, so anyone can call to the SIM-
card number if there is no security numbers list protection and this call may cause
unwanted reboot or microphone activation. Accordingly, if you are going to disable the
security numbers list protection, then the option
RING
goes into the value "
NOACTION
"
automatically.
In response to the activating call the device will send you a message. You can configure
a call response instead of an SMS. Read more about this in Chapter 6.2. The following
table indicates which actions can be pre-configured.
Summary of Contents for GSM 706
Page 1: ......