iSMA-B-MG-IP User Manual
www.ismacontrolli.com
DMP260en | 1st Issue rev. 6 | 05/2022
page 10 of 29
•
•
•
•
•
4.7 Front Panel
4.7.1 LED Indicators
Figure 5. The iSMA-B-MG-IP LED indicators
The power LED (ON) is on (green) if the device is running properly.
The communication M-BUS LED is on (green) for 20 ms after sending each message by
the M-Bus bus. If the device receives/sends a lot of messages, the LED can be lit
continuously.
The communication COM1 LED is on (orange) for 20 ms after sending each message
by the RS485 port. If the device receives/sends a lot of messages, the LED can be lit
continuously.
The communication ETH1 LED is on (orange) for 20 ms after sending each message by
the Ethernet. If the device receives/sends a lot of messages, the LED can be lit
continuously
The ALM LED is ON (green) if an overload is detected on the M-Bus bus (current on the
M-Bus bus exceeds 130 mA).
4.8 Default Settings
Out-of-the-box device, as well as after restoring default values procedure, has the
following default registers values:
Register Name
Default Value
BAUD RATE
115200 (115200 bps)
STOP BITS
1
DATA BITS
8
PARITY BITS
0
RESPONSE DELAY
0
USERNAME
platform
PASSWORD
1000
IP ADDRESS
192.168.1.123
MASK
255.255.255.0
