Temporary and Permanent Hold
Temporary Hold:
The thermostat will display “Hold” and “Run Sched” on the left side of the
screen when you press the “+” or “-” key. If you do nothing, the temperature will remain at
this setpoint temporarily for four hours. After this time, the thermostat will revert back to
programmed temperature control.
At any time during temporary temperature hold, press the
Run Sched
button to exit
temporary temperature hold.
Permanent Hold:
The thermostat will display “Hold” and “Run Sched” on the left side of
the screen when you press the “+” or “-” key. If you press the
Hold
key at the left side of
your screen you will see “Hold” appear above the setpoint temperature in the display. The
thermostat will now permanently stay at this setpoint and can be adjusted using the “+” and
“-” keys.
At any time during permanent temperature hold, press the
Run Sched
button to exit
permanent temperature hold.
Filter Change Reminder
If the filter change reminder has been set, you will see a reminder (“Filter”) appear in the
display when your air filter needs to be changed. Note: Once a reminder has been set in the
technician setup menu, the elapsed time can be checked by navigating to the Filter Change
Reminder screen, then press the key below the Next Step key.
The reminder will appear after the system has run long enough to exceed the number of
hours set in the Tech Setup Menu. To reset the filter change reminder, change your filter
and then hold down the second key from the top for five seconds.
19
Programming
Summary of Contents for 6041228
Page 2: ......
