•
Use one or two clips to fasten the misting line onto the umbrella fabric between the nozzles on the rib ends, as
shown:
•
Repeat the previous steps until each tee-fitting and nozzle on the misting line has a clip on either side (except
for the last nozzle fitting).
NOTE: Be sure to stretch the misting line tight during installation to prevent sagging.
Option B:
How to install the misting kit using the
elastic loops sewn on the umbrella cover:
•
Position the elbow fitting at the end of the selected umbrella rib.
•
Run the lead line along the umbrella pole up to the umbrella rib end.
•
Use one of the cable ties to clamp the tubing onto the umbrella pole and the rib.
NOTE: If your umbrella is anchored by a patio table with a hole only large enough for the umbrella pole,
do not run the tubing through the patio table hole in addition to the umbrella pole. It will restrict the
water flow and damage the lead line tubing.
•
Starting with the rib end, where the elbow fitting is positioned, insert the assembled misting line through
one of the elastic loops.
•
Moving in the opposite direction from the elbow fitting, wrap the assembled misting line around the
complete circumference of the umbrella, inserting the misting line through the elastic loops as you go.
•
The misting line will connect with the open end of the elbow fitting once it has been completely wrapped
around the umbrella.
•
It is helpful to have an extra person assist during this part of the installation process.
NOTE: Be sure to stretch the misting line tight during installation to prevent sagging.
•
You may need to use some of the clips to further secure the misting line to the umbrella if it is sagging.
•
Finish the installation by connecting the elbow fitting to the open end of the misting line.
