V. Assembly
Please read the safety notice carefully before assembly and make the assembly according to
the following steps.
Tools: wrench (2 pcs)
1. Checking the input voltage
There is correct input voltage in the label on microscope. Make sure the voltage in your
position is right. Improper input voltage may cause short circuit and fire. The microscope will
be damaged. Turn off the power supply (turn the switch to O ) and insert one end of the
electronic cord (connector) into the entrance for AC. Insert the other end of the electronic
cord (pin) into the grounded AC connector and make sure that the electronic cord has been
connected safely
_ Please use the supplied electronic cord by manufacturer
_ Please make sure to use PE electronic cord when using extra-long electronic cord.
_ Pay attention that the microscope should be placed near AC connector and the AC
connector is touchable for users
2. Removing the clamps for transportation
The clamps fix the stage and focusing adjustment firmly during transportation.
Handle the grooves beside collector and pull it out.
Remove the clamps by wrenches.
_ Mechanical stage
There is one clamp fixing the mechanical stage in
Y axis direction. Remove the bolts and clamps.
_ Focusing adjustment
Pull out the collector. The bracket is fixed by one clamp. Please remove the bolts and clamps.
3. Mount the binocular head
Loosen the fixing screw in the eye tubes and insert the binocular head into the eye tubes.
Then tighten the screw.
4. Mount the blue filter
Take out the filter from the bottom of condenser and mount it in the bracket then move the
bracket into the condenser.
5. Adjustment and replacement
1_Condenser
The condenser is mounted in the microscope before shipment. Remove or replace the
condenser according to the following steps
a. Handle the grooves of the condenser and pull it out
b. Turn the lifting knob for condenser and make the bracket in a suitable position
c. Loosen the screw in the left side of condenser and take out the condenser. Mount the blue
filter in the bracket then move it into the bottom of the condenser. Make the label in the
condenser forward and move the condenser into the bracket. At last tighten the screw.
d. Handle the grooves and push the condenser in.
e. Turn the lifting knob of condenser and make the condenser to the highest position.
