Turned tool changing station SK11 and SK20
10
/
27
April 2019
5. External I/O pin configuration
Pin Signal
Identification
1
+24V
+24V voltage supply
2
User IN1
Input 1, freely programmable in the user software
3
User IN9
Input 9, freely programmable in the user software
4
User OUT1
Output 1, freely programmable in the user software
5
GND 24V
GND voltage supply
6
LMT IN
Length measurement transducer input, optional
7
User IN2
Input 2, freely programmable in the user software
8
User IN10
Input 10, freely programmable in the user software
9
User OUT2
Output 2, freely programmable in the user software
3.2
Pneumatic connection
No. Description
1
Connection to compressed air supply
The turned tool changer requires an operating pressure of 8 bar and must be connected to
a maintenance unit. Required hose diameter 6mm.
4
Assembly and commissioning
4.1 Assembly of turned tool changing station SK11, SK20
Ensure that you have a stable and secure foundation for the turned tool changing
station prior to commissioning. Avoid collision with other components of the
machine.
4.1.1
SK11 assembly
Figure 2: SK11 fastening
Fasten all five fastening points on the turned changer to the
mounting area of your machine with machine screws (not included
in the scope of supply) and ensure that it is flat and level.
Attention: The turned changer must be positioned in the
travel range of your CNC machine.
