CNC control panel iOP-19-TFT
Page - 8
No.
Element
Description
1
Power ON button
Switches the power amplifiers on.
2
Fault indicator
The fault indicator signals the presence of a fault in the safety
circuit.
3
STOP button
Interrupts the NC program currently being executed. Pressing
the STOP button a second time terminates the NC program
currently being executed (does not apply to all control
configurations, only to the ProNC setting).
4
START button
Pressing the START button initiates execution of the current
NC program or, where the program has been interrupted,
allows the current program execution to be continued.
5
ACK (acknowledge)
button
The ACK button is used in Set Up mode and must be pressed
to allow the shafts to be driven when the cover is open.
6
COVER button
The COVER button is pressed to allow the cover to be opened
(where a cover has been provided). The cover can only be
opened when the conditions listed under "Operating Mode
Selector Switch" have been fulfilled. Once the white signal
lamp on the COVER button is illuminated, the cover can be
opened.
7
Operating Mode
Selector Switch
This key switch allows the unit to be switched between the
Automatic Operation and Set Up modes. In Automatic
Operation, the cover (or door) of the machine can only be
opened when the shafts are not in motion and the cutting
spindle has been switched off. In the Set Up mode, the cover
(or door) of the machine can only be opened when the working
spindle has been switched off. In the Set Up mode, the shafts
can be activated with the cover open by pressing the ACK
acknowledgement button.
8
EMERGENCY
STOP button
Pressing this button immediately disconnects the power supply
to the motor, converter and working spindle.
Switching into the AUTO ->TEST operating mode whilst the workpiece is
being machined brings the working spindle to a halt. Switching back to the
AUTO mode restarts the working spindle. Before switching back to the
AUTO operating mode, ensure that all moving parts are in the stop
position. Failure to do this can result in damage to the working spindle or
workpiece.
No.
Element
Description
9
PC START button Switches the computer "on" and "off".
10
Two-handed
operation
Control buttons for two-handed operation (optional)
