8. WiFi
The CC24 Master crate controller is optionally equipped with a removable WiFi access point.
In case this feature is unwanted, you can switch it off by software configuration (see 11.2.3 iCSconfig: manage hardware, service
and preferences) or remove the USB-hardware part from the controller board or front panel USB port.
For more information of WiFi configuration and use, refer to the iCS section (see 11.2.1 How to connect via WiFi).
9. Module Bitrate Configuration
INFORMATION
INFORMATION
All modules must be configured to a CAN bitrate of 250 kBit/s for operation with CC2x controller series.
If modules are configured to a CAN bitrate of 125 kBit/s, they can be re-configured by the crate controller in a
bitrate configuration mode.
Carefully follow these steps to prepare modules for use with the CC2x crate controller series:
1.
The crate is connected to mains power, the backplane is turned off, no module is plugged in
2.
No connector is plugged into the CONTROL socket of CC 2x crate controller
3.
Press and hold the pushbutton
POWER-ON
for about five seconds
4.
The LED STATUS blinks slowly GREEN
5.
If a module is recognized now, the controller switches into normal operation mode
◦
If no module is recognized, the controller enters CONFIGURATION MODE
6.
The LED STATUS blinks quickly, the controller scans for a module at both bitrates
7.
Insert exactly one module which bitrate should be adapted (by hot plugging).
◦
If the module is recognized on the wrong bitrate (i.e. 125 kBit/s), it will programmed to the correct bitrate
(250 kBit/s) and restarted afterwards
8.
If the module is (now) recognized at the correct bitrate, the LED STATUS blinks slowly
9.
The module can be plugged out now and another module can be plugged in to repeat the configuration process from
step 5
10. Press the button
POWER-ON
for about one second to turn off the crate and exit the CONFIGURATION MODE
INFORMATION
INFORMATION
In case of the need of reconfiguration to 125 kBit/s, the provided Bitrate Configuration dongle (shortens Pin 2
and Pin 9) must be connected to the CONTROL connector before starting the configuration. The LED STATUS
blinks red instead of green in this case. You can contact iseg customer support for purchase accessory parts.
Crate Controller CC24/CC23 | Last change on: 14.04.2020 |
www.iseg-hv.com
18/44
