ISANTA Senco Smart Load SHS51XP, Installation Instructions Manual

Page: 7 / 39

7
GB
7 Malfunctions
MALFUNCTIONS
DESCRIPTION CAUSE ACTION
Attachment unit does not work Staple sensor does not register any
staples.
Check if the sensor works properly
by placing a staple bar on the loading
plate. The red light of the sensor must
now switch on, and switch off again
when you remove the bar.
Staples stuck in staple compartment. Pressure in the loading cylinder is ei-
ther too high or too low. The pressure
can be adjusted by the Senco service
engineer.
Staple stuck in guide body. Open the nozzle and remove the
staples.
No or insufficient compressed air. Check the compressed air (7-8 bar)
Material sensor does not register any
material.
This can be checked by detaching the
hose from the remote control. If air
escapes from the hose during opera-
tion of the tacker the tacker needs to
be repaired.
Compartment empty Fill the compartment
Control unit does not work Contact the supplier
Attachment unit stalls during moving Stapling is too deep. Increase distance between guide body
and material.
Stapling depth is uneven Insufficient supply of compressed air The pressure at the Smart Load
needs to be stable
Compressed air pressure too low The pressure is 7-8bar.
Material is too hard or its structure is
too uneven
8 Disposing of the Smart Load
When the system is scrapped, the regulations for waste disposal in force at the location and time of scrapping
must be observed. The system is constructed only of generally known materials. At the time of construction,
there were possibilities for waste processing and there were no known special risks for people responsible
for scrapping. The attachment unit and tools must be handed in to a sustainable recycling company (see
European Parliament and Council Directive 2012/19/ EU)
9 Technical data
Dimensions
Length: 444 mm
Width: 123 mm
Height: 280 mm
Weight: 10 kg.
Noise: >100 dB(A)
TECHNICAL DATA
Pneumatic
Compressed air: 6-8 bar
Consumption: 2,5 litres/ tacking
Load capacity: Vertical compartment for 21 staple bars
Operation: 24 Volts DC