9
ISABELLA LX
USE AND MAINTENANCE MANUAL
428000085137
EN
R404A
3. WASTE DISPOSAL
During normal operation, the equipment does not generate any environmental
contamination. At the end of its life cycle, or if it is necessary to proceed to permanent
decommissioning, we recommend following the procedures below:
DISPOSAL (User)
The symbol, applied to either the product or its packaging, indicates that the product should
not be considered as normal domestic waste, but should be taken to a waste collection point
for the recycling of electrical and electronic appliances. The correct disposal of this product
helps to prevent potential negative consequences that might derive from inadequate product
disposal. For detailed information about recycling this product, contact your council, your local
waste collection service or the store where you purchased the product.
END-OF-LIFE DISPOSAL AND RECYCLING PROCEDURES
FOR THE EQUIPMENT
(Authorised Bodies)
1. Switch off the equipment and unplug the power supply cable.
2. Remove the lamps (if installed). These should be disposed of separately.
3. Remove the control boards and the electronic cards. These should be disposed of
separately.
4. Remove all the independent parts (grids, casings, profi les, etc.) and group them
according to shared features in order to access the heat exchangers, pipes, cables, etc. and
be careful not to damage the cooling circuit.
5. Remove all mobile parts (doors, sliding doors, glass parts, etc.) and group the various
materials according to their features.
6. Check the type of coolant on the label located inside the counter. Remove the coolant
and dispose of it through authorised services.
7. Disconnect the evaporator, condenser, compressor, pipes and fans. These are made of
copper, aluminium, steel and plastic and should therefore disposed of separately.
8. Once all the guardings and the various parts of the frame have been removed, separate
the various types of material they are made from (plastic, metal sheets, polyurethane,
copper, etc.) into groups according to their features.
All recyclable materials and waste should be processed and recycled by professionals, in
compliance with the laws of the country in question.
The company responsible for recycling the materials should be registered and certifi ed as a
waste disposal service in accordance with the specifi c directives of the country in question.
Attention
Illegal disposal of the product by the owner will result in administrative sanctions as required by
current laws.
Disposal of the product should comply with current laws on the disposal of coolant liquids and mineral
oils.
Important
If there is no symbol representing a barred dustbin on the equipment, this means that the
manufacturer is not responsible for taking care of the disposal of the product. In this case, again,
current waste disposal laws should be complied with.
Additional information
Further information on the disposal of liquid coolant, oils and other substances is available on the safety
data sheet corresponding to the substance itself.
Summary of Contents for ISABELLA LX 10
Page 26: ......
