iDS6
Series User’s Manual
iS5 Communications Inc.
36
Technical Specifications
Physical Ports
10/100 Base-T(X) Ports in RJ45
Auto MDI/MDIX
2
P.O.E. Feature (optional on iDS6)
P.O.E.Present on ETH2
Power Device (IEEE 802.3af): IEEE 802.3af compliant input interface,
Power consumption: 8 Watts max., Over load & short circuit protection,
Isolation Voltage: 1000 VDC min., Isolation Resistance : 108 ohms min
Serial Ports
Connector
iDS6: 4x RS232 / RS422 / 2-wire RS485 / 4-wire RS485
iDS6P: 4x RS422 / 2-wire RS485 / 4-wire RS485
Connector
iDS6: Male DB9
iDS6P: 5 pin terminal block
Serial Baud Rate
110 bps to 460.8 Kbps
Data Bits
5, 6, 7, 8
Parity
odd, even, none, mark, space
Stop Bits
1. 1.5, 2
RS-232 signals
TxD, RxD, RTS, CTS, DTR, DSR, DCD, RI, GND (iDS6 only)
RS-422 signals
Tx+,Tx-, Rx+, Rx-,GND
RS-485 (4 wire) signals
Tx+,Tx-, Rx+, Rx-,GND
RS-485 (2 wire) signals
Data+, Data-,GND
Flow control
XON/XOFF, RTS/CTS, DTR/DSR
Serial Line Protection
Built-in15KV ESD protection
2KV DC isolation for each port (iDS6P only)
LED Indicators
PWR PoE
Green: Normal operation, Red: Booting, Blinking Red: IP conflict, or DHCP
or BOOTP server did not respond properly
PWR 1
Green: Normal operation, Red: Booting, Blinking Red: IP conflict, or DHCP
or BOOTP server did not respond properly
PWR 2
Green: Normal operation, Red: Booting, Blinking Red: IP conflict, or DHCP
or BOOTP server did not respond properly
Fault
Red: Fault occurred
S1, S2, S3, S4
Blinking Green: Tx Data, Blinking Red: Rx Data
Eth 1 (Link and Act)
Green On/Blinking: 100Mbps LNK/ACT
Amber On/Blinking: 10Mbps LNK/ACT
Eth 2 (Link and Act)
Green On/Blinking: 100Mbps LNK/ACT
Power Requirements
Power Input
LV: Dual 10-48VDC
input
MV: Dual 36-75VDC
input
HV: Single Input 88-
300VDC or 85-264VAC
with a Single 10-48VDC
backup
Overload Current Protection
Present
Reverse Polarity Protection
Internal
Power Consumption
7 Watts typical, 15 Watts MAX (7 Watts typical and 8 Watts PoE)
