Hardware Guide
Ethernet - Ethernet PoE
©2012 IRTrans GmbH
10
4.3 Devices with 2X option
IRTrans modules with 2X option offer a second independent output for external
transmitters. The IRTrans PoE is equipped with a second 3,5mm jack for this
purpose. The IRTrans Ethernet uses a stereo plug for the second output.
5. Connecting external IR receivers
External receivers can be connected by a 3,5mm jack next to the built in IR recei-
ver.
When using an external receiver it must be enabled in the device settings and the
correct receiver type has to be selected.
Older IRTrans Ethernet modules (up to hardware revision 2.2) cannot select the
receiver by software. When using an external receiver with this devices a jumper
has to be set inside the IRTrans. This jumper is located behind the built in recei-
ver and will disable the internal receiver thus enabling the external input. This is
not necessary with current revision or PoE devices.
When using external receivers firstly the receiver must be enabled and
secondly the correct receiver type has to be selected with the IRTrans
software.
6. RS232 interface
Instead of connecting an external IR receiver the connector may be used as a
serial communication port. To use this a special active RS232 cable is required
and the connection can only be uni directional.
Summary of Contents for Ethernet PoE
Page 1: ...Hardware Guide Ethernet Ethernet PoE Version 2013 02...
Page 16: ......
