DDA-4010
IRT Electronics Pty Ltd | www.irtelectronics.com
Page 9 of 21
Revision 01
Dual 1 In, 4 Out Quick Set-up Guide:
Note that in Dual 1 In, 4 Out mode, each half of the DDA-4010 behaves as an independent DA, which means that
each input can be set with different (or the same) data rate and Reclock/Non-Reclock mode settings.
Input A to 4 x Output A, and Input B to 4 x Output B:
Sw1-5 = ON
(Dual 1 In, 4 Out mode).
Sw2-5 = Not Applicable.
Reclocking Mode:
Sw1-3 = OFF
(Input A reclocked. A input behaves as a reclocking DA).
Sw2-3 = OFF
(Input B reclocked. B input behaves as a reclocking DA).
Non-Reclocking Mode:
Sw1-3 = ON
(Input A non-reclocked. A input behaves as a non-reclocking DA).
Sw2-3 = ON
(Input B non-reclocked. B input behaves as a non-reclocking DA).
Reduced equalisation in a noisy environment:
Sw1-4 = ON
(Input A cable equalisation reduced).
Sw2-4 = ON
(Input B cable equalisation reduced).
Automatic Changeover Mode:
On loss of one input, other input will switch to all 8 outputs. See
Operation
section for complete description.
Sw1-7 = OFF
(Auto Changeover disabled).
Sw1-7 = ON
(Auto Changeover enabled).
