1. INTRODUCTION
2. IMPORTANT SAFETY INFORMATION
Irradio thanks you for purchasing this video projector and for the confidence you placed in our brand.
Thanks to our constant commitment in searching innovative and environmentally friendly technologi-
cal solutions, we believe that we will be able to fully satisfy every of your needs.
Before use and installation of the video projector, please read carefully this manual: it contains
important information, needed to fully and safely use the product. Store this manual in a safe place for
possible future use.
The Irradio technical service is at your disposal for any questions or further information: e-mail
address [email protected].
• Before proceeding with the projector installation, check its integrity: if any anomalies or damages are
detected, do not switch on the unit and contact the retailer or distributor.
• The projector is intended for indoor use only, in residential, commercial and service environments: if
it is used in bad weather, safety requirement is not guaranteed.
• Before to proceed with installation, check that the mains voltage is correct, 220-230 V AC 50 Hz.
• The device can be installed either on a flat surface or on the ceiling: in this case, it is necessary to
provide brackets and/or supports and the installation must be carried out by specialized personnel:
a poorly executed installation can lead to the fall (and damage) of the appliance, with possible injury,
even serious, to people.
• If installed on a flat surface, check for possible obstacles nearby that could make unsafe the use.
• If the projector will not be used for long time, disconnect it from the mains and remove the batteries
from remote control.
• This device is not a toy and can be dangerous for children, even after disposal, as some parts could
be ingested if disassembled.
• Avoid using the projector in excessively hot, cold, dusty or humid places, in presence of gas, smoke
or direct sunlight, even with window glasses interposed.
• During operation, the projector emits a very intense light from the front lens: strictly avoid looking
directly at the emitted beam, in order to avoid injury to the eyes.
• In case of use by children or people with reduced cognitive and / or motor skills, adequate
supervision must be guaranteed.
• If the projector emits unusual noises, smoke, bad smell or if abnormal deformations or cracks of the
casing are detected, proceed as follows: disconnect the power supply using the switch on the
electrical panel, disconnect the projector from the mains and only then restore the electrical panel.
Contact a qualified technician.
• Please use only the original accessories: the use of non-original accessories may result in
malfunction and/or damage, loss of technical safety requirement and warranty invalidation.
• Avoid contact with liquids: do not place the projector near taps, steam vents, water tanks, surfaces
with strong condensation. No basin with water must be placed near or on top of the projector.
• Before cleaning the product, please disconnect the power cable from the mains: refer to the next
chapter for the relative prescriptions.
• There are no serviceable parts inside: do not dismantle. Any repair or technical verification must be
carried out by technical people only. Dismantling the unit will invalidate the guarantee and can be
dangerous for the user.
• If installed on the ceiling, pay special attention at the quality of bracket fixing to the ceiling and the
projector; verify the masonry as well the tightening of anchors and screws. A poorly executed
installation can lead to the fall (and damage) of the appliance, with possible injury, even serious, to
people.
• Also check that the projector installation will not obstruct the windows or doors opening and that, in
ceiling installation, the lower part of the projector will be at a minimum height of 2.50m from the floor.
• The projector installation must not be an obstacle for moving elements as split air conditioners or
ceiling fan: also avoid to place the unit along the air flow line generated by them, nor in the proximity
of lamps, spot lights or other lighting devices, especially if they produce a strong heating, nor along
the luminous flux line generated by them.
• Please avoid connecting the projector to controlled sockets, timers, electromechanical actuators,
power strips, multisocket adapters and electrical extension.
• Do not insert any metal object in the air or sound emission holes, nor in the signal connectors: only
the appropriate connector must be used. Do not block the ventilation slots.
• Do not use the projector for any purpose other than exactly that described in this manual; the
intended use is residential, the projector is not suitable for intensive professional use.
• Do not leave the projector unattended during operation.