9 of 10
Replacing the glass and door rope
To maintain a safe operation of the stove door any
damaged glass should be replaced immediately. Remove
the door by lifting from the hinges and lay down on a soft
flat surface. Remove the glass fixing strips and fit new glass
into position. Be careful not to overtighten the screws as
this can break the glass. To fit a new door seal remove the
rope and any residue adhesive. Insert rope adhesive into
the channel and replacement rope. Wait approximately 12
hours for the rope adhesive to set before using the stove.
Glass dimensions: 407mm x 310mm
Rope diameter: 10mm (soft rope)
Seasonal use
Over the summer months, when the stove is not in use
remove all ash and soot from within the ash pan and above
the baffle plate. Set the air control to the halfway position
as this will reduce any build-up of moisture in the stove
and reduce any corrosion. In the event that there is rust
on any of the components this can be removed using wire
wool and 2 light coats of stove paint.
After a prolonged period of not using the
appliance check for blockages will need to be
made before re-lighting.
