Ironwood FX 750 | User Manual
21
9.0 Maintenance
WaRninG
Never operate the machine until it has been properly lubricated and
all necessary maintenance work has been completed.
Before performing any type of maintenance or adjustment, make
certain that the machine is shut off and disconnected from its
power source.
9.1 Lubrication
It is important to periodically apply a drop of light machine oil on the
ledge and walls of the table opening to aid in the changing of table
rings. Note: Do not get oil on the pulleys or belts.
The bearings in the motor are sealed for life and do not
require lubrication.
The spindle bearings require lubrication every 200 hours of use.
To lubricate, use the grease gun provided with the machine:
1. Locate the two grease fittings positioned opposite each other
on the spindle housing.
2. Clean the fittings thoroughly.
3. Lubricate using two pumps of the grease gun in each fitting.
4. Clean off any excess grease.
9.2 Inspection
Caution
After changing a setting, making an adjustment, performing repair,
maintenance or troubleshooting, check that all safety functions are
working properly before restarting machine.
9.3 Periodic Maintenance
Periodic cleaning increases the life of the machine and enhances
performance. Vacuum the inside of the machine as wood shavings,
dust or other debris will accumulate.
To replace ball bearings, contact Stiles Machinery’s Parts Dept at
1-800-727-8780.
Feature
Interval/Situation
Spindle ball bearings
Lubricate every 200 hours of use.
Belt
Replace every 1,000 hours of use or whenever it becomes frayed.
Emergency stop
Every day. Press to check prior to operation.
Interlocked guards
(door lock, spindle lock)
Monthly. Open each guard one at a time to stop the machine. Confirm
machine will not start with each guard in the open position.
Mechanical brake
Every 100 hours of operation or by doing a brake function test to check
that the machine stops within the specified time (less than 10 sec.)
Electrical cabinet/system
Monthly. Inspect for loose wiring terminals and insulation deterioration.
Spindle
Every day. Clean spindle and main shaft with compressed air daily.
Pulleys and Belts
Monthly. Inspect for wear and proper tension.
Table Surface
Monthly. Wax table surface to prevent rust and lubricate for easy panel
movement.
