Page of 16
12
between you and the cutting disc and turn the tool ON. If the cutting disc wobbles or the tool
vibrates, turn the tool OFF immediately and investigate and correct the cause.
OPERATION
ON/OFF SWITCH
WARNING:
Before starting the tool, make sure the cutting disc is in good condition,
is properly installed and not in contact with any surface.
This tool has a combination lock-out and ON/OFF switch to avoid unintentional starting of the tool.
To turn the switch ON:
1. Grasp the tool with two hands.
2. Press downward on the rear of the ON/OFF switch with your
thumb (FIG. 5).
3. While pressing downward on the rear of the ON/OFF switch, slide
the switch forward to start the tool.
NOTE:
The ON/OFF switch will click into the lock-on position
when the switch button is pushed fully forward. The tool will
continue to operate until the switch is turned OFF.
4. To turn the tool OFF, press downward in the rear of the switch
button.
APPLICATION
GENERAL CUTTING
DANGER:
Always clamp the work piece firmly into a vise or to a stable work surface.
Never hold the work piece with one hand and the tool with the other hand. Severe injury may
result.
WARNING:
Always wear appropriate eye, ear and breathing protection and protective
clothing when operating the cut-off tool.
1. Mark the work piece where the cut is to be made.
2. Firmly clamp the work piece in a vise or to a stable work surface.
3. Grasp the tool with both hands, turn the tool ON and wait until it reaches full speed.
4. Carefully place the edge of the cutting disc onto the work piece surface.
5. While cutting, keep the tool moving over the work piece, while maintaining a steady pressure on
the cut-off disc.
NOTE:
Do not force the tool by applying too much pressure. The tool will slow down and will not
cut properly. It will also damage the motor.
When the cut is completed, release the ON/OFF switch and allow the cut-off disc to stop before
putting the tool down
MAINTENANCE
FIG 5