24
Door Gasket
Glass Retainer
Glass Retainer
Hex Head Screws
10 ea.
Glass with Gasket
Upper
Hinge Pin
Lower
Hinge Pin
Back View of Door
Back View of
Doorframe
GLASS REPLACEMENT INSTRUCTIONS
(Refer to
Figure 36
)
Step 1. Remove Door Assembly
- Remove the upper and lower hinge
pins by pressing the bottom of each hinge pin up, then pull out
from the top. Lift off door and place face down on a soft surface.
Step 2. Remove Glass Retainer Screws (10 ea.)
- Using an 1/8” allen
wrench remove the ten glass retainer screws. To locate screws,
peel back the door gasket as necessary. The screws are located
by the holes in the stainless steel glass retainer strips.
Step 3. Remove Glass
- Carefully remove broken glass one piece at a
time (protective leather gloves are recommended).
Step 4. Clean Door Frame
- Clean the area of the door frame where the
new glass with gasket will be installed.
Step 5. Install New Glass Assembly
- Install the new glass with gasket
(use only factory supplied 5mm ceramic glass with gasket.
Do
not substitute
).
Step 6. Reinstall Retainer and Screws -
Carefully reinstall the glass
retainer and screws. Be very careful not to overtighten the screws
(this could result in glass breakage when the stove is hot).
Step 7. Reinstall Door
- Align hinges on door frame with corresponding
hinge holes on the face of stove. Reinstall the upper and lower
hinge pins from the top.
MAINTENANCE
Figure 36 - Glass Replacement
Locate screws (10 ea.)
(peal back gasket as shown)
Arrows indicate
screw locations
CAUTION
Cleaning Glass: Ensure appliance is cold prior
to cleaning glass. A commercial glass cleaner
designed for stoves is recommended. Do not use
abrasive cleaners. Do not clean with any materials,
which may scratch or otherwise damage the glass.
Scratches on the glass can develop into cracks or
break. Inspect the glass regularly. If you detect a
crack, extinguish the fire and contact your dealer
for a replacement.
GLASS CLEANING GUIDELINES
WARNING: DO NOT CLEAN GLASS WHEN APPLIANCE IS HOT!
Glass on any wood stove will not stay perfectly clean. Here are some
guidelines for cleaning and caring for the glass:
• Ensure the stove is cold prior to cleaning glass.
•
This appliance is designed to provide a flow of air over the inside of
the glass, where along with high heat helps inhibit build-up on the
glass. When build-up occurs, a commercial glass cleaner designed
for stoves is recommended.
Regular household glass cleaners will
not clean creosote.
• Do not use abrasives such as steel pads, steel wool or oven cleaner
as they will scratch the glass. Never scrape glass with a razor blade
as this may pit the glass and make it impossible to clean in the future.
• Do not use chemical glass cleaners as they may damage the gaskets
or painted surfaces.
TIPS FOR KEEPING THE GLASS CLEAN
• Burn only dry seasoned cord wood.
Wet wood = Dirty glass.
• A short, hot fire (15 - 20 minutes) may help to clean off some of the
normal buildup.
Lower burns = more build-up. Higher burns = less
build-up.
• Keep freshly loaded wood away from the glass.
• After reloading, allow all the wood to catch flame before dampering
down the stove.
