6
Difficult to connect or remove Super Bench on
Tower
The height of the stub may need to be adjusted to line
up well with the bench receiving tube. Loosen the stub
mounting bolts and adjust then tighten.
Use some silicone lubricant on the stub.
Uneven floor or thick carpet can cause some difficulty
sliding the bench onto the stub. Consider using on a
different flooring surface or in a move level area
.
Tower tilts or tips over
Be sure to only pull the cables in line with the bench
and not sideways.
Try using a lighter weight when not seated on the
bench or when pulling while not braced against the
unit.
Weight carriage does not slide smoothly
It is important to use plain silicone lubricant. Do not use
WD-40 or other oil based lubricant.
Clean off the slide rail with a dry clean cloth before ap-
plying silicone spray to remove any buildup.
Be sure the carriage is installed in the correct position
as per the assembly instructions and diagrams.
Cable comes off the pulley wheel
Check that the tension of the cables is correct with no
excess play. Adjust with tension bolt as needed.
Do not slam weight carriage or let go of the handle
causing the carriage to bounce off the spring. If the
cable comes off a pulley, remove all the weight form
the system and carefully lift the cable back into the pul-
ley wheel .
Weight carriage slams at the top
Adjust your position during exercise to change the
range of motion.
Use the included chain to extend the rage if necessary.
Troubleshooting guide-Cable Tower