Page 13 of 18
BBR085E
Installation Guide
©Copyright 2022 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
28.
Assemble and install light bar into the
centre bar section using the supplied
brackets and hardware. The brackets
provide some adjustment to ensure
centralized positing and vertical aim
of the light. Light bar cable can be
secured to the small holes found on
the inside edge of bull bar using cable
ties.
Brackets N#11 & N#12. Hardware
N#27 2X (M8x1x20mm bolt, washer,
spring washer nut) & N#28
2x (M6X1X20mm bolt, washer, spring
washer nut).
NOTE:
Optional centre light bar
ILBDR002B.
29.
Assemble and install Ironman 4x4
cube lights to light pod. The brackets
provide some adjustment to ensure
centralized positing and vertical aim of
the light. The Cube Light cable can be
secured to the inside edge of bull bar
using cable ties.
30.
If you are not fitting the optional light
bar. There is a mesh infill supplied.
You will still need to use the Light
bar support brackets to install mesh.
Bracket N#11 & N#12. Hardware N#27
2X (M8x1x20mm bolt, washer, spring
washer nut) & N#28 2x (M6X1X20mm
bolt, washer, spring washer nut).
31.
Install license plate mount bracket
onto Bull bar N#26 2x (M6x1x20mm
bolt, washer flange nut).
If winch is being installed, fit the
fairlead as well.
