Page 11 of 18
BBR085E
Installation Guide
©Copyright 2022 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
20.
NOTE:
If installing the control box with
supplied bracket, it is advised to drill
a 6mm drain hole in the lower control
box housing. Making note to not
damage internal components.
IMPORTANT:
For parking sensors to
function correctly these instructions
must be followed closely. Before
removing sensors from original
bumper bar, note the location and
orientation of each sensor so when
they are fitted back into the Raid bar
this can be replicated.
21.
Remove the parking sensor wiring
and parking sensors from the factory
bumper taking note of the direction
and position of each sensor.
Remove grommets from the sensor
holes in Raid bumper.
22.
Fit sensor with factory silicone sleeve
to the sensor holder. Use flat side of
clamping plate to secure the sensor.
The sensor will false alarm if excess
pressure is applied to the sensor body.
23.
Clean inside the Raid bar, around
sensor holes and mounting surface of
parking sensor holders using grease
and wax remover.
