Page 12 of 16
1. Identify your vehicle information in the Vehicle Mounting Ribs Measurements
table. You have by this stage assembled the frame and are now ready to install
the specific locations of the floating ribs (1PFR and 2PFR) to the frame to suit
your vehicle.
2. You will notice along the inside bottom flange of all bearing panels there are
various holes punched, this is where you need to fix the floating ribs in the
positions you will get from the Matrix. There are two floating ribs with two
different mounting positions. Refer to Diagram 1. Some vehicles may only
require 1 floating rib as the front or back rail may be used.
3. Most vehicles will have standard width floating ribs, in some rare cases such
as a Pajero. In this case the floating rib needs to be longer and therefore is
supplied as a two piece. This is to accommodate vehicle fixing mounts that are
outside the drawer system’s width, the fixings to the frame remain the same as
the positions used in the Matrix. Refer to Page 14 for installation diagram.
4. The position measurement (A & B) is taken from the front edge of the lock rail to
the rear edge of the floating rib.
5. Your required fixing position of the floating ribs will line up with existing holes.
6. Use M6 x 16mm Pan Head screws provided to mount the floating ribs to frame.
Hardware Listing
Floating Rib Installation
NOTE: As this system is made to suit multiple vehicles, you will have some
hardware left over.
WASHERS
PACKERS
BOLTS
NUTS
4 x M10 x 25mm
2 x M6
4 x Mudguard
4 x 20mm
4 x M10 x 35mm
2 x M6 x 35mm
4 x M10 Nyloc
VEHICLE
APPLICATION
VEHICLE
MODEL
MEASUREMENT
“A” (mm)
MEASUREMENT
“B” (mm)
Mitsubishi Pajero
(NM, NP, NS, NT)
GL, GLX, GLS,
VRX, EXCEED
(2000 on)
174
640
Landrover
Discovery 2
(ES, S ,SE, HSE,
SE7)
FEB 1999 -
2004
223
BR
B
A
FRONT
OF
DRA
WER
SYSTEM
Diagram 1
Vehicle Mounting Ribs Measurements
Drawer System Instructions