Save the newly modified CONFIG.CFG onto the Z-397 WEB removable drive. Properly
disconnect the device from computer. When the power is restored, the device will register
itself onto the LAN using new parameter values.
The device already connected to the LAN can be configured via Telnet protocol. Before that,
the device should be properly configured to work on the LAN. To start remote configuration
session, connect to the device using
“
TELNET <device_ip_address>
”
command. If the
device IP address is not yet known, use the Device Search Utility from a supplied CD.
After Telnet connection is established, authentication prompt will appear looking like this:
5.2. Configuration using Telnet protocol.
Enter AUTH_KEY:
>
Type the converter authentication key and press ENTER.
The authentication key is printed on the sticker attached to the device's back, as well as in
the device passport.
You can now type control commands.
page 6
Z-397 WEB
www.ironlogic.me
Параметр
Описание
Заводские значения
[TC P_SER VER] section TCP SERVER mode settings
LINE1_PORT=XXXXX
LINE2_PORT=XXXXX
TC P port to listen on when working
with RS-485 lines.
1000
1001
LINE1_ALLOWED_IP=XXX.XXX.XXX.XXX
LINE2_ALLOWED_IP=XXX.XXX.XXX.XXX
Allowed IP addresses to accept
incom ing connections from
(255.255.255.255 = Incoming
connections allowed from any
address)
255.255.255.255
[T CP_CLIENT] section TCP CLIENT mod e settings
LINE1_REMOTE_ADDR=XXX.XXX.XXX.XX
X
LINE2_REMOTE_ADDR=XXX.XXX.XXX.XX
X
Rem ote server address
0.0.0.0
LINE1_REMOTE_PORT =XXXXX
LINE2_REMOTE_PORT =XXXXX
Rem ote server port
0
[RS485] sectio n RS-485 line settings
L1_BAUD RATE=XXXXXX
L2_BAUD RATE=XXXXXX
RS485
lines
baud
rate
values
(300
…
115,200), in bits per second
(bps)
19200
