Ironkids 8030, Owner'S Manual, Page: 18 / 19

17
For Concrete Ground Installation:

If the swing set is set up on grounds with sandy soil condition, it must be anchored with concrete
footing (concrete not included).

Dig holes at least 5” (12.7cm) deep and 10” (25.4cm) to 12” (30.5cm) in diameter around legs as
shown below in drawing. As you dig down and create a cylindrical hole, you should use a shovel
to carve out the lower part of the hole, to create a larger diameter hole at the bottom. Be sure
the leg is set 3” (7.6cm) below the ground.

Place 2 inch high brick or 2 inches of gravel bed as shown in drawing below.

Use about 45lb of concrete per leg.

Cover concrete with dirt and protective surface material.

Allow about 6-7 days for concrete to dry properly.
Warning: Please bury the legs of the merry go round as per
instruction. If the merry go round is used without proper
anchoring, it may be dangerous and may tilt over.
This merry go round complies with ASTM-F1148-09.
Brick or gravel bed
2 inc
h
es
10-12 inches
Concrete
Leg
5 inc
h
es