Ironkids 8030, Owner'S Manual, Page: 10 / 19

9
ASSEMBLY INSTRUCTIONS
For easier assembly, we have preassembled some of the parts for you. Most of the bolts should
already be in place. If removal of this hardware is required for certain assembly steps, it should be
replaced in its original position. If it isn’t necessary to remove the hardware, check to make sure it
is tight before allowing children on the Merry Go Round.
Only adults should assemble or disassemble the Merry Go Round. For safety reasons and ease of
assembly it is recommended that two adults assemble the Merry Go Round. The Merry Go Round
includes two 5mm Allen wrenches and one 3mm Allen wrench.
Points to remember when locating and placing the Merry Go Round:

Place the Merry Go Round equipment on level ground, not less than 6 feet (1.83 meters) from
any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines,
or electrical wires.

Do not install the Merry Go Round equipment over concrete, asphalt, packed earth, or any other
hard surface. A fall onto a hard surface can result in serious injury to the user.

Do not place the Merry Go Round underneath electrical lines. If you must, ensure that there is
a minimum overhead clearance of 6 feet (1.83 meters).

The Merry Go Round should be assembled near the location it will be permanently anchored.
TIGHTENING BOLTS

Do not over-tighten the bolts when you are assembling your Merry Go Round equipment. This
will allow for some possible adjustments and ease of installation.

Once you have completed the assembly of the Merry Go Round equipment, go back over all of
the bolts and properly tighten all of them before using the Merry Go Round equipment.
WARNING!
Unexpected movement (i.e.: tipping, lifting and overturning) of the Merry Go Round may result in
serious injury or death. The Merry Go Round must be securely anchored before use.