7
A. Slide the Actuator(F) to the last set of welded tubes
on the Main Extension Arm(B), Using a 16mm x 29cm
Hex Bolt(K), two 16mm Flat Washers(U) and a 16mm
Lock Nut(M) at the top. And using a 14mm x 12cm Hex
Bolt(I), two 14mm Flat Washer(T) a 14mm Lock Nut(J)
on bottom to tight the Actuator.
STEP 3
STEP 4
A. Attach the Plastic Rim Height Indicator(G) and the Spring
-assist Cartridge(E) to the second set of welded tubes on
the Main Extension Arm(B) by using a 16mm x 29cm Hex
Bolt(K), two 16mm Flat Washers(U) and a 16mm Lock
Nut(M). The Plastic Rim Height Indicator(G) should hang
freely along side the Spring-Assist Cartridge(E).
B. Attach the bottom of Spring-assist Cartridge(E) to the welded
Actuator Bracket by using a 14mm x 12cm Hex Bolt(I), two
14mm Flat Washers(T) and a 14mm Lock Nut(J).
C. Remove and discard the blue plastic spreader tube from the
Spring-Assist Cartridge(E).
STEP 5
A. Attach the 2 Upper Extension Arms(C) to Main Post(A)
with a 16mm x 26cm Hex Bolt(L), two 16mm
Flat Washers(U) and a 16mm Lock
Nut(M).
NOTE: It does not matter which end of the Upper
Extension Arms you attach to the Main Post(A).
CAUTION: Injury may occur if Upper Extension
Arms are allowed to fall off Main Extension Arm
during assembly.
K
U
U
M
I
T
T
J
F
K
U
U
M
G
E
I
T
T J
L
U
U
M
C
