Ironclad TRIPLE THREAT TPT-443, Assembly Instructions And Owner'S Manual

Page: 6 / 8

! !
WARNING
*BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF
THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS*
STEP1
A. Slide a 16mm Thick Washer (Q) over each of the J-Bolts(N) as shown in FIGURE 1A.
B. Place the Main Post(A) over the J-Bolts. Slide a 16mm Thick Washer(Q) and thread a 16mm Flange
Nut(S) to each J-bolt.Tighten the Nuts only a few turns onto the J-Bolts as shown in FIGURE 1B.
C. If the Main Post (A) is not exactly vertical, adjust the 16mm J-Bolt Hex Nuts(R) located under the
Post base. Tighten all of the Flange Nuts(S) when Main Post(A) is vertical.
NOTE: Face the Main Post(A) with Actuator Bracket facing away from playing court(as shown in FIGURE 1C).
6
STEP2
A.
Slide the Main Extension Arm(B) over the
top of the Main Post(A) and attach to the
lower pivot tube with a 16mm x 29cm Hex
Bolt(K), two 16mm Flat Washers(U) and a
16mm Lock Nut(M).
K
U
U
M
B
A
S
Q
A
S
Q
S
Q
S
AI
Q
Q
Q
Q
O
R
R
R
R
FIGURE 1A
FIGURE 1B
Playing Court
Back
FIGURE 1C