INTRODUCTION
Dual Module Marine Docking Camera Unit
CONNECTIONS
The IM-DCS-01 Dual Module Water Resistant Camera adopts the latest SONY tech-
nology, CCD Sensor and driver.
Key features of the DCS-01 are itʼs attractive, stylish housing, environmental protection
(IP66 - Itʼs water resistant but donʼt submerge!), ease of installation and setup and high
resolution.
Each housing includes 2 camera modules mounted on fully adjustable brackets that
allow the user to obtain near 180 degree coverage.
The IM-DCS-01 is perfect for use as a docking camera, and can either be used as a
pair of housings (4 cameras) looking forward and aft, port and starboard, or mounted
sideways with each camera module focused on the port and starboard aft quarters.
Please ensure installation is carried out by qualified engineer and that the device is
properly connected to the power source. This equipment must be suitably isolated to
prevent damage or risk of injury. For further technical support please contact your
dealer, or Iris Innovations using the contact details within this document.
The DCS-01 camera is fitted with a cable tail which has a 2.1mm DC Jack for the
power and two female BNC connector for the video signal. The polarity of the power
connection is center pin = +12V, connector body = Ground.
Use a suitable coaxial cable with an impedance of 75Ω for the video signal or a suit-
able Video Balum if using Cat 5 cable.
Ready made power, video and combination cables are available from Iris Innovations.
Video (1v P~P Composite 75Ω)
2 Inputs
12VDC 300mA
Connect to boatʼs distri-
bution panel and ensure
suitable isolation is in
place.
Chart Plotter / Dedicated Monitor /
DVR or Video Switching Equipment.
Summary of Contents for IM-DCS-01
Page 1: ...IM DCS 01 USER GUIDE ...
