Iridex EndoProbe, Operator'S Manual

Page: 33 / 44

27
Troubleshooting
Reporting problems
Should you experience problems with your probe when using it with an
IRIDEX laser, refer to the suggestions in this section. If you continue to
experience problems, write down the error message, product name, serial
number of the console, and lot number of the probe before contacting your
local IRIDEX Technical Support representative.
Problem Action
Inadequate or no aiming beam • Ensure that the probe is
properly connected to the
console.
• Ensure that the console is in
Treat mode.
• Turn the Aiming Beam
control fully clockwise.
• Ensure that the fiber-optic
connector is not damaged.
• If possible, connect another
IRIS Medical delivery device
and place the console in
Treat mode. If the aiming
beam is still not visible,
contact your local IRIDEX
Technical Support
representative.
No treatment beam • Ensure that the remote
interlock has not been
activated.
• Ensure that the aiming beam
is present and bright.
• If you still have no treatment
beam, contact your local
IRIDEX Technical Support
representative.
• If used, ensure that the
two-position eye safety filter
is in the closed position.
REFERENCE
Should you experience
problems with your probe
when using it with a non-
IRIDEX laser, refer to the
Troubleshooting section
of your laser operator
manual.
For connection
instructions, see the
Operation sections of
your console manual and
this manual.