IR Ingersoll Rand 6LH1A1, Operation And Maintenance Manual

Page: 2 / 27

2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by
the hose.
WARNING WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
90 psig
(6.2bar/620kPa)
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 10 Ingersoll–Rand No. 67
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
USA – C18–03–FKG0–28
Motor
Before starting the Tool and after each eight hours of
operation, unless the air line lubricator is used, detach the
air hose and inject a few drops of oil into the air inlet.
Gearing
For models with H, J, JJ, K, or L gearing, after each
50,000 cycles or 160 hours of operation, whichever comes
first, inject 6 – 8 cc of Ingersoll–Rand No. 67 Grease into
the Grease Fitting.
For models with M, P, or R gearing, after each 50,000
cycles or 160 hours of operation, whichever comes first,
inject 10 – 12 cc of Ingersoll–Rand No. 67 Grease into the
Grease Fitting.
Angle Head
For models with the 7L1A1 Angle Attachment, after
each eight hours of operation, inject 0.5 – 1 cc of
Ingersoll–Rand No. 67 Grease into the Grease Fitting.
For models with the 7L2A4 or 7L3A4 Angle
Attachment after each forty hours of operation, inject
0.5 – 1 cc of Ingersoll–Rand No. 67 Grease into the Grease
Fitting.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)