Vertiq 8108 150Kv
Connect your communication wires to your arduino, computer, etc.
Mount your module to the application
If communicating over UART, use the IQ libraries (available at
) to
send commands to your module*
*For more detailed instructions on communicating with the modules, refer to the ReadTheDocs page at
6
Connect Computer via USB to UART
This is the recommended method for communication.
Connect your FTDI, CP2102, CP2104 or similar device to USB
Using jumper wires connect (see images below):
–
The GND of your USB to UART device to the GND (black) wire on the motor
–
The TX of your USB to UART device to the RX (white) wire on the motor
–
The RX of your USB to UART device to the TX (red) wire on the motor
V1.0
©
2021 IQinetics Technologies Inc.
6
CONNECT COMPUTER VIA USB TO UART
