iQMS362 CE
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
, E
N
General
This section describes the machine
’
s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.
WARNING!
NEVER USE A MACHINE THAT HAS
FAULTY SAFETY EQUIPMENT
BLADE GUARD
The blade guard is designed to prevent parts of
the blade or cutting fragments from being thrown
towards the user.
CHECKING THE BLADE GUARD
Check that the guard over the blade is not cracked or
damaged in any other way. Replace when damaged.
DUST GUARD
The dust guard is designed to prevent dust being pulled
up from the backside of the blade. The dust guard should
be inspected periodically for damage. The dust guard
should move freely sliding up and over cutting material.
NEVER USE THE MACHINE
WITHOUT A GUARD NOR WITH A
DEFECTIVE GUARD. ALWAYS CHECK THAT THE GUARD IS
CORRECTLY FITTED BEFORE STARTING THE MACHINE.
IT IS NOT PERMITTED TO EXPOSE THE BLADE MORE THAN
180 DEGREES WITHOUT PROTECTION.
WARNING!
WARNING!
SHUT DOWN THE MACHINE AND
DISCONNECT THE POWER PLUG.
MACHINE’S SAFETY EQUIPMENT
MACHINE POWER SWITCH
To start the machine press the green button (A) on the
switch. NOTE: Machine is protected by the GFI switch
reset button (D). This must be pressed each time
machine is connected to power.
To stop the machine, press the red button (B). NOTE:
Machine is protected by a built-in thermal circuit
breaker (C).
Defective switches should be replaced by an authorized
service workshop.
LOCKING KNOB, ROLLING TABLE
The locking knob is used to lock the rolling table in place
when in transit. Be sure to lock rolling table before
transit to avoid injury.
5.1
Blade Guard
Dust Guard
A
B
C
D
