iQMS362 CE
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
, E
N
ADJUSTING THE TOP SLOT
Note: The top slot adjustments are set at the factory
so adjustment will only need to be performed after
extended use or after parts replacement.
The gap between the top slot and rolling table louvers
should be set at 1/32” (.8mm) or less (A). The top slot
and rolling table louvers should not be touching or
rubbing during table motion. If they are rubbing, an
adjustment is necessary.
ADJUSTMENTS
NOTICE!
PROPER GAP BETWEEN THE
TOP SLOT IN ROLLING TABLE
LOUVERS IS CRITICAL TO MAINTAIN VACUUM AND GOOD
DUST COLLECTION.
12.1
ADJUSTING THE ROLLING TABLE UPPER ROLLER
With Allen wrench secure axle cam screw(V),
loosen axle nut (W).
With Allen wrench turn axle cam screw till there is a
slight resistance when rotating upper roller by hand.
While holding Allen wrench and axle cam screw in
position tighten axle nut to secure.
Follow the same procedure for all six upper rollers.
1.
2.
3.
4.
ADJUSTING AND SQUARING THE ROLLING TABLE
Note: The rolling table is set squared to the cutting
head at the factory and is certified to be within an
industry-leading standard of 0.015” or 1/64” (.38mm).
Adjustment will only need to be performed after
extended use or after parts replacement.
V
W
A
