It is recommended that the lamp is fitted before the lantern is fixed to the wall.
Fit the lamp as follows.
Release the hexagonal nuts on the top cover of the lantern see Diagram A and remove the top
cover.
IMPORTANT!
If you intend to benefit from the addition of the OPTIONS module, please refer to the OPTIONS
control module instruction manual for advice on assembly and set up.
If you intend not to use the OPTIONS module,the blanking plate
MUST
be fitted to maintain
Safety Regulations!
Fit Blanking Plate supplied by simply inserting into the aperture shown on diagram B. Ensure
blanking plate is fully secured to ensure a watertight seal. There will be an audible click and the
cover will fit securely into its circular aperture.
If the blanking plate is missing from this product, DO NOT INSTALL, please contact the
Consumer Helpline below.
SECTION TWO
SELECTING THE LOCATION
If it is your intention to use the OPTIONS control module, for best results mount at height of
1.8m. See OPTIONS module instruction manual for more details.
SECTION THREE
INSTALLATION
After choosing a suitable location (see previous section) install the unit as follows:
The unit is suitable for connection to a 240V 50Hz electricity supply. It is suggested that
3-core round flexible cable of 1mm² gauge is used. An internal switch should be installed to
switch the power to the unit ON & OFF. This allows the lantern to be easily switched off when not
required or for maintenance purposes.
*** IMPORTANT ***
Switch off the electricity at the fuse box by removing the relevant fuse or switching off
the circuit breaker before proceeding with the installation.
PARTS INCLUDED
- Luminaire
- Instruction manual. Please keep safe for future reference.
- Wall fixing screws and wall plugs
- Blanking Plate
- Wall plate
TOOLS & PARTS NEEDED
- Electric/hand-held drill & bits.
- Terminal or Electricians screwdriver
- Large slotted/philips screwdriver
- Wire cutters
- 1.0mm sq. round flexible cable
- 60W Max GLS ES Lamp (refer to Section 5 for further details)
This lantern is for outdoor use only. Unit must be mounted on a non-flammable surface as a
fixed luminaire, and is not suitable for portable use.The unit can get very hot during use. Ensure
the unit has cooled before handling.Ensure adequate ventilation space is allowed between the
unit and any object above, in front or to either side of the unit. Suggested space is 0.5m above,
0.3m to either side & 1.0m in front. Do not attempt to install during wet weather, if you are
suffering from nausea or dizzy spells or on medication with similar side effects
If in any doubt, consult a qualified tradesperson or electrician.
