CONNECTION
It is recommended that the circuit is protected by a 5A max fuse or circuit breaker.
It is recommended that this product is connected to fixed wiring only.
Connect the cable to the terminal block on the unit as follows (see connection diagram):
LIVE (Brown)
L
EARTH (Green/Yellow)
NEUTRAL (Blue)
N
Ensure that the connections are secure and the terminal block is securely located on its mounting
posts.
This product uses a fast fix connector and it is imperative the connector is aligned when
assembling the lantern onto the wall plate.
Lift the lantern onto the wall plate, ensure that the screws at either side of the lantern bracket
are aligned with the holes in the wall plate, this will ensure the pin connections of the fast fix
connector are aligned with their receptacles.
Replace the top cover and secure the two fixing screws.
Ensure the decorative "handle" is located in the slot at the rear of the lantern.
Fully secure the lantern fixing screws See Diagram A.
Installation is complete.
The unit is ready for mounting to the wall.
The wall bracket is packed seperately, remove from packaging.
Based on the location of your incoming cable,use the wall plate as a template and mark the
position of the mounting holes. See diagram C.
Ensure the wall plate is in the correct orientation by referring to the to arrow marked "TOP" See
Diagram C, note that the wall plate is placed in a VERTICAL position for this product.
Drill holes and insert wall plugs into the holes.
Pierce and pass the cable through the grommet before securing the wall plate to the wall.
Fit the wall plate to the wall
Do not overtighten, if using a power screwdriver ensure it is set to the lowest torque setting to
prevent damage to the wall plate.
CONNECTION DIAGRAM
Mains
Supply
Isolation
Switch
N
E
L
N
E
L
