IPTC Albatross™ DEX28-GE2P – Quick Installation Guide
3
Connect a Terminal or PC to the Console Port
The console port is a service port to which you can connect a terminal or PC in order to configure the software by
using the command line interface. To connect a terminal or PC to the console port, follow the steps:
1.
Connect the RJ-45 patch cable to the gateway’s console port and RJ45-DB9 adapter.
2.
Connect the DB-9 connector to at terminal or PC.
Connect LAN to the Ethernet Port
To connect DEX28 to local area network, follow the steps:
1.
Connect one end of the RJ-45 patch cable to the gateway’s Ethernet port.
2.
Connect the other end of the RJ-45 patch cable to Ethernet hub/switch directly. Connection can be also
made indirectly through patch panel or wall outlet.
Connect the Power and Turn-On the Gateway
Caution:
Be sure to use the power supply that was supplied with your DEX28 gateway.
To connect the AC adapter to the DEX28 gateway and turn it on, follow the steps:
1.
Connect one end of the power supply cable to the gateway’s input jack.
2.
Connect the other end of the power supply cable to the desktop power adapter.
3.
Plug the power cord of the desktop power adapter into an electrical outlet.
The blue LED on the front panel of the gateway lights when you connect the gateway to a power source. The
gateway is now ready to be used. If the blue LED does not turn on, refer to the “Troubleshooting the gateway”
chapter.
!
Ethernet Switch
IP
RJ45 STP
Patch Cable
RJ45-DB9 Adapter
Power Supply
Adapter
Power Supply
Cord
