User Guide
IPico™ WN400 Integrated Access Device
User Guide © 2001 Lucid Voice
18
WAN.
See
Network Setup
. The WAN parameters should change only if
you have a router between the two IP
ico
units.
WAN Netmask.
This is the address space assigned to your WAN. This
value should match the one used by other devices on your WAN.
Master IP Address.
Enter the IP address of the Master IP
ico
WAN
interface. To avoid conflicts with other nodes on your network, this
address must not be assigned to any other node on your WAN or LAN,
including the Slave.
Slave IP Address.
Enter the IP address of the Slave IP
ico
WAN interface.
To avoid conflicts with other nodes on your network, this address must
not be assigned to any other node on your WAN or LAN, including the
Master.
Default Gateway.
Enter the IP address of the WAN gateway. If you have
a third-party router on your WAN, enter its IP address here. If you do not
have a router, this address should be the WAN IP address of the peer IP
ico
device on your network.
