IPG INTERPACK USA 2024-BFF, Operations Manual & Parts List

Page: 17 / 72

UM136TW UDM136-01
16
S
ET
-U
P
P
ROCEDURES
B) Tape Threading
W
ARNING
! T
HE KNIFE CONTAINED IN THE
T
APE
H
EAD IS EXTREMELY SHARP
. U
SE
CAUTION WHEN REMOVING THE BLADE GUARD AND THREADING THE
TAPE TO AVOID PERSONNEL INJURY
.
To thread the tape in the upper Tape Head, you do not require any special tools.

Push the Tape Head towards the front of the machine and lift up.

Pull approximately twelve (12) inches of tape from the roll and fold in half
lengthwise. This allows you to thread the tape without it adhering to the guide
and clutch rollers inside the Tape Head.

Follow the tape-threading diagram on the side plate of the HSD

2000 Tape
Head. Refer to your Tape Head manual for further information if required.

Flip the blade guard from the knife in the Tape Head.

Cut off the folded tape.

Replace the upper Tape Head to its initial position.
To thread the lower Tape Head, no special tools are required.

Lift the top Tape Head box to the uppermost position.

Remove the lower Tape Head by grasping the tape application rollers and lifting
straight up.

Pull approximately twelve (12) inches from the roll and fold in half lengthwise.
This allows you to thread the tape without it adhering to the guide and clutch
rollers inside the Tape Head.

Follow the tape-threading diagram on the side plate of the HSD

2000 Tape
Head. Refer to your Tape Head manual for further information if required.

Flip the blade guard from the knife in the Tape Head.

Cut off the folded tape.

Replace the lower Tape Head to its initial position.