The units come with an optical interface that allows all parameters to be set and ad-
justed by a PC or notebook.
The suitable interface cable and Windows-Software can be ordered with the article
number
AD000011
.
With the Software you are able to adjust all functions described above.
NOTE:
Use a shielded cable socket (e.g.
VK205
A
21
), in order to
avoid interferences.
mounting and electrical connection
For wall mounting you can order a mounting clip with the article-no.
AY000060
.
After mounting the sensor mechanically, the control panel can be rotated by 350° to
align it for the machine operator.
The unit must be connected by a suitably qualified electrician. The national and in-
ternational regulations for the installation of electrical equipment must be observed.
Voltage supply to EN50178.
The device shall be supplied from an isolating source and protected by an overcur-
rent device. Disconnect power before connecting the unit as follows:
MANUAL • Subject to alteration! Version:
June 2017
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
15
