the teach-in procedure relating to through-beam sensor operation:
1. Aim the sensor towards the background and/or the machinery part.
2. Connect the Teach-In line (white, PIN 2) to + UB for longer than 2 seconds (however less than 5 seconds). The red LED flashes.
3. Connect the Teach-In line again to +UB for a short period.
4. If the sensor is intended to work as a make contact (output switched if an object is detected), then connect the Teach-In line
again for a short period with +UB. Otherwise the device works as a break contact.
5. The Teach-In process is completed as soon as the red LED is lit for 2 seconds.
6. If the sensor is `teached in' outside of its detection range, a warning signal will be displayed (rapid flashing of the red
LED). The device is then set at its maximum operate distance.
teach-in of the ON – / OFF position (2-point Teach-In)
1. Aim the sensor towards the background and/or the machinery part.
2. Connect the Teach-In line (white, PIN 2) to + UB for longer than 5 seconds with +UB. The red LED flashes rapidly.
3. Connect the Teach-In line again to +UB for a short period.
4. Place the object between the sensor and the background and connect the Teach-In line to +UB again for a short period.
5. The device works as a make contact (output switched if an object is detected). If points 3 and 4 are swapped around, the
device works as a break contact.
If the sensor is `teached in' outside its detection range, or the margin between the teach positions is too narrow for a
secure operation, a warning signal will be displayed (rapid flashing of the red LED). The sensor will then retain its previous
setting.
alignment mark
Connect the teach-line to +UB for more than 10 seconds. The red LED flashes rapidly
.
Break the connection.
If the red LED goes out now, this means that no signal is being picked up by the receiver. A LED that flashes slowly means that there
is a weak signal. A LED that flashes fast means that there is a strong signal. If the LED is illuminated permanently, then the alignment
is ideal. In order to return to the normal mode, connect the Teach-In line for a short period with +UB.
soiling indicator
If the sensor has been `teached in' as a make contact, the red LED flashes if the sensor is soiled.
notes:
The above status information applies to a „plus switching“ (pnp) connection.
For a „minus switching“ (npn) connection the status information has to be inverted.
Under normal operations, the Teach-In line must be grounded (0V)!“
electric connection
dimension drawing
e.g.
VK200375
suitable cable socket:
Warning:
Never use these devices in applications where the safety of a person depends on their
functionality.
* transmitter axis
wire colors
: bn = brown (1), wh = white (2), bu = blue (4), bk
= black (4)
Teach-in-input
switching output
MANUAL
• Subject to alteration! Version:
November 2012
ipf electronic gmbh
• Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 www.ipf-electronic.com
2
