Subject to alterations
Version 1.0
IPCOMM GmbH
- 5 -
SEC3ER Manual
Walter-Bouhon-Strasse 4
Copyright © IPCOMM GmbH, 2021
90427 Nuremberg
All rights reserved
Germany
2.3 Ethernet Line Breaker E1-E4
The industrial breaker for Ethernet lines consists of three functional areas:
The status indicators
– E1-E4
The mechanical control switches
– E1-E4
Ethernet relay
ports arranged in pairs
– E1-E4
Figure 3: Ethernet relays E1
– E4
A 3-way switch is provided for each Ethernet interface pair E1-E4 to manually control their
communication state.
ON
– Manually switched on
REMOTE
– Control via Software
OFF
– Manually switched off
In the switch position REMOTE, software control is possible via a communication protocol or via a
graphic web interface (
WebConfig
- diagnostic area).
Bistable relays are used as "ON/OFF switches" for each of the eight individual lines of an Ethernet
connection. . These remain in their current state even after a power failure or other interruptions. The
partner interfaces are connected or disconnected to each other with the same pin configuration (1:1).
For the RJ45 interface description see chapter 2.4.4 Ethernet-Relays E1-E4.
For the Diagnostic LED
’s see chapter 3.2 Status LEDs E1-E4.
