21
To configure port mirroring settings, do as follows:
1)
Select a mirroring destination port (only one).
2)
Select a mirroring source port (you can select one or more mirroring source ports but only one
mirroring
destination port).
3)
Select a proper Sniffer Mode (mirroring mode): None, Ingress, Egress or Egress & Ingress.
4)
Click
OK
to complete your settings.
Fields on the screen are described below:
Field
Description
Mirroring
Destination
Port
Select the port to which port traffic is copied.
Sniffer Mode
Select a sniffer mode for a corresponding mirroring source port.
Important:
None: Indicates corresponding port is not mirrored.
Ingress
：
Only incoming packets are copied to the monitor port.
Egress
：
Only outgoing packets are copied to the monitor port.
Egress & Ingress: Both inbound and outbound packets on the corresponding port are
copied to the monitor port (mirroring destination port).
Source Port
Select the port from which the packets are mirrored
IMPORTANT:
1)
A mirroring destination (monitor) port and mirroring source port should not be the same port.
2)
A port in an aggregation group should not be configured as a mirroring destination (monitor) port.
3)
A STP-enabled port should not be configured as a mirroring destination (monitor) port.
4)
The bandwidth of the mirroring destination port should not be smaller than that of the mirroring source port(s).
5)
A mirroring destination (monitor) port should be directly connected to a server that can monitor network
traffic.
3. Statistics
Statistics displays the number of RX, TX, collision, drop and CRC error frame on each port.
To enter statistics interface below, click
Port Management
>
Statistics
.
Summary of Contents for F1226P
Page 1: ......
