ioWave ioLink 4, User Manual

Page: 27 / 69

User Guide: Technical Reference SECTION 3 OPERATING THE ioLink 4
PRELIMINARY
Customer Support (202) 333-7031
-3-3
3.1.3 ioLink 4 LCD Menus
The currently selected item is indicated by parenthesis (the defaults are indicated below). When an item
changes, the entire display flashes to indicate that the change has been completed.
Table 3-2. Liquid Crystal Display (LCD) Menu Defaults
STATUS CONFIG TEST ALARM* ADVANCED
Status Menu
<- Next Menu -> Config Menu
<- Next Menu -> Test Menu
<- Next Menu -> Alarm Menu
<- Next Menu -> Advanced Menu
<- Next Menu ->
RF Signal Level
xx% Encoding
(B8ZS) AMI Full Loopback
(Off) On Alarm 1 … BER Threshold
2.0 E-7
Signal Level
xx% T1 Data Cable
(133) 266 399
533 655 Far-end Loopback
(Off) On Alarm 2 … BER Interval
100 s
Pre-FEC BER
x.x E-x TX Code
(1) 2 3 4
Source Loopback
(Off) On Jitter Atten
(RX) TX None
Data Rate
T1 RX Code
(1)
2 3 4
Channel Plan
(A1) A2
Set Factory Def
(No) Yes Acquire Thresh
050H
Data Rate
E1 RX Code
(2)
2 3 4
Channel Plan
(A1) A2
Set Factory Def
(No) Yes Acquire Thresh
050H
Software Version
1.1.0 Store Config
(No) Yes Symbol Thresh
010H
Firmware Version
2.1.0 Set Factory Def
(No) Yes FEC BER
(Off) (On)
Serial Number
MUXXXXX FEC Loopback
(Off) On
Channel Plan
A1 .. A2 LIU Loopback
(Off)Loc RM Net
BER Threshold
2.0 E-7
BER Interval
100 s
* When there are active Alarms, they will be displayed via this menu.