Page 2
FLEX
CEILING
TILE
LED DRIVER AND ARRAY
COMPARTMENT
TBTS
Lorem ipsum
STEP 1 -
MOUNTING THE ILBLP CP HE SD HV
The
ILBLP CP HE SD HV
should be mounted on or nearby the
fixture above the ceiling. The flex conduit should be wired into
the driver/lamp compartment or to an electrical junction box on
the fixture which allows access to the fixture connections.
TBTS
ILBLP CP HE SD HV
SPECIFICATIONS -
Illustration 1
Model
ILBLP CP20 ... HV
ILBLP CP30 ... HV
Output Voltage (Min - Max)
40-200 VDC
40-250 VDC
Minimum Operation
90 Minutes
90 Minutes
Input Voltage (Min - Max)
120-277 VAC
120-277 VAC
INSTALLATION INSTRUCTIONS
CAUTION: Before installing, make certain A.C. power is off and the Threaded Body Test Switch (TBTS) is disconnected.
STEP 3 -
INSTALLING THE THREADED BODY TEST SWITCH (TBTS)
A. Locate a suitable location for the TBTS
and cable that is visible outside the fixture.
Drill or punch a 1/2” diameter hole in the
luminaire wall or wireway cover. Insert the
TBTS into the hole so that the LED test
button is located outside of the fixture.
B. Secure the TBTS against the
luminare housing by screwing
on the TBTS nut.
C. Connect and fully engage the TBTS
Connector to the TBTS Socket. Ensure the
TBTS Connector is properly seated in the
TBTS Socket, then mark the TBTS location
on the switch box plate with the TBTS Label
and apply the SD Status Indicator Sticker.
FLEX
CEILING
TILE
LED DRIVER AND ARRAY
COMPARTMENT
TBTS
Lorem ipsum
TBTS
ILBLP CP HE SD HV
LUMINAIRE HOUSING
LUMINAIRE HOUSING
TBTS NUT
TBTS NUT
Remote Mounting
- The TBTS may be remote mounted from the fixture up to 25 feet.
Before extending the TBTS wires,
ensure that AC Power is off and the TBTS has been disconnected.
To extend the TBTS wires, splice the TBTS leads
between the test switch and connector and install a patch cable (minimum 18 AWG) of the desired length to the spliced ends.
Be sure to observe wire color. After extending the TBTS wires, follow the installation procedure (steps A, B, and C) above to
recconnect the TBTS.
STEP 2 -
WIRING TO THE LED LOAD AND NORMAL DRIVER
ILB-LP NORMAL DRIVER AND LED LOAD CONNECTIONS
ilbcp_tspl_normal-driver-and-load-only.eps
AC (NORMAL)
DRIVER
IOTA ILBLP
EMERGENCY DRIVER
LED
LOAD
WHITE
WHT/RED
RED (+)
BLUE (-)
YELLOW
BROWN
LEDCODE (+)
LEDCODE (-)
VIOLET/WHITE (+)
LED INPUT(-)
LED INPUT (+)
LED OUTPUT (+)
LED OUTPUT (-)
!
Cap unused
LEDCODE wires
Refer to the appropriate wiring diagram below. Make sure all connections are in accordance with NEC and any other
local requirements.
The ILBLP CP HE SD HV is designed to interface with high voltage (non-class 2) LED Loads.
See
Illustration 1
for output voltage ratings per ILBLP model.
