STEP 3. Attach the mount
Retract the 2x Azimuth (Azi) Adjustment Screws from both sides to leave ample space for the alignment
peg to fit in between the 2 Azi Adjustment Screws. Remove the 2x Azi Locking Screws, with washers, from
the mount base. Secure the mount head by tightening the Azi Locking Screws into the M6 holes on the
tripod. An Allen wrench is included for convenience.
Figure 12. Attach the mount
Level the mount by adjusting the tripod legs. Use the build-in Bubble Level Indicator or an external leveler
for this purpose.
STEP 4. Adjust latitude
Without any payload, slightly loosen the 4x Latitude Locking Screws. Use the Latitude Adjustment Knob to
set the correct latitude value, as displayed in the Latitude Mark Window. Insert the Allen wrench into the
Latitude Adjustment Knob for more turning torque.
Figure 13. Adjust latitude
Two latitude ranges, 14~44° and 36~68°, can be set up for the mount head. To change the latitude range
from one to the other,
both
the Latitude Position Bolt and the Latitude Locking Screws need to be moved to
the correct locations (see photos below).
Loosen the Latitude Locking Screws just enough to adjust the latitude setting to 40°. Move the Latitude
Locking Screws with washers (one on each side) to the new locations revealed, do not tighten them just yet.
Allen wrench
Azi. Adj. Screw
Azi. Lock Screw
Azi. Lock Screw
Lat. Lock Screw
Lat. Adj. Knob
Lat. Mark
